Identyfikacja wariantu#
Nazwa modelu: Matek SAM-M10Q-5883 GNSS GPS Module
MPN producenta: —
SKU podane przez sklep: MATE-SAM-M10Q
Typ produktu w katalogu sklepu: GPS
Wariant: Default Title
Parametry techniczne#
| Parametr | Wartość |
|---|---|
| Producent | MATEK |
| Antena | Patch antenna 15 x 15 x 4mm |
| Liczba jednoczesnych GNSS | Maximum position availability with 4 concurrent GNSS reception |
| Złącze | JST-GH-4P connector (SM04B-GHS-TB). 1.27mm pitch |
| Obsługiwane konstelacje | 1x Matek SAM-M10Q-5883 GNSS GPS Module |
| Firmware | UBX protocol is bidirectional. Flight controller firmware can change settings on GPS via UBX protocol. You don’t need to set GNSS module Baud and Frequency in u-center. |
| Interfejs do autopilota | UART(TX, RX) interface for GNSS SAM-M10Q-00B |
| Napięcie zasilania | 4~9V (5V pad/pin) |
| Interface | UART(TX, RX) interface for GNSS SAM-M10Q-00B |
| Magnetometr | Tilting the magnetometer is strongly discouraged ! |
| Materiał | Make sure to have compass/magnetometer 10cm away from power lines/ESC/motors/iron based material |
| Operating temperature c | -20~80 °C |
| Protokoły danych | UBX(u-blox) 5Hz@GPS+GAL+BDS B1C+GLO or NMEA 1Hz |
| Odbiornik GNSS | The SAM-M10Q provides the ability to reset the receiver. Bridging “RST” pad to Ground for at least 100 ms will trigger a cold start. RESET will delete all information and trigger a cold start. It should only be used as a recovery option. If you are sure wiring and setup are all right. but flight controller can’t detect the GNSS module(grey GPS icon), try doing reset. |
Sklepy i ceny#
| Sklep | Wariant | Cena |
|---|---|---|
| RaceDayQuads | — | 40,99 USD |